![]() ![]() If you can install package hal (not installed by default on recent Ubuntu versions), this command will work for you as non-root: lshal | grep Lrwxrwxrwx 1 root root 0 Nov 14 14:59 subsystem ->. r- 1 root root 4096 Nov 25 17:12 product_serial ![]() r- 1 root root 4096 Nov 25 17:12 chassis_serial Unfortunately, someone decided that all information in that virtual directory is open to anyone for reading, just not the serial numbers: $ ls -l /sys/devices/virtual/dmi/id The same information is also provided by the Linux kernel via sysfs in a virtual directory, /sys/devices/virtual/dmi/id. There is currently no specific troubleshooting information available for this configuration.Dmidecode reads this information from physical memory, using /dev/mem, which requires root. There is currently no verification procedure available for this configuration. To remotely read the serial number, issue the show module command, which lists information about the installed modules, including the serial numbers. Serial numbers for line cards are printed on the bottom of the metal card tray. The serial number is found below the product number. It can be read from the sticker on the back of the unit next to the power supply or it can be read remotely by issuing the show sprom backplane 1 command. The chassis serial number on a MDS 9000 series multilayer switch is used to identify the unit for service contract purposes. Conventionsįor more information on document conventions, refer to the Cisco Technical Tips Conventions. ![]() If your network is live, make sure that you understand the potential impact of any command. ![]() All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is based on the MDS 9000 storage area networking operating system (SAN-OS). Prerequisites Requirementsīefore attempting this configuration, ensure that you have remote access to the MDS 9000 series multilayer switch through an IP or console connection. This document explains how to read chassis and line card serial numbers through remote access to the MDS 9000 series switch. You might have to do so for inventory requirements or for confirmation or verification for support contract entitlement. Occasionally, you might need to remotely read serial numbers from your MDS 9000 series multilayer switch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |